Submersible pond pumps are used to pump water in garden ponds or fountains. They can be used to circulate the water for fish to breathe and for fountains to operate.
Submersible pumps work seven days a week and are just like an external pump. This allows you to enjoy your pond anytime.
Submersible pumps are preferred by many people because they can be used in smaller ponds. They are simple to install and very reliable.
Pumps are rated according to how much water they can carry through. There are many models available, ranging in size from 60 GPH for an indoor fountain to 6000 GPH for a large backyard waterfall/pond. Pumps provide oxygen to the pond fish and clean the water through filters. They can also push water up and above a waterfall, creating beautiful water sounds that enhance the garden’s atmosphere.
These are five easy steps to install a submersible pump in your garden.
-
- Your pump should be placed on the bottom of your pond. Pumps that are clogged with dirt can cause them to run slower and ultimately reduce their life expectancy. To keep the pump from slipping onto the pond’s surface, place it on a block or stack of rocks. Make sure the pump is completely submerged in water.
- The flexible tubing should be set so that the water is directed to the place you desire.
- The hose clamp should be attached to the pump by securing the clamp to the hose. Place the clamp so it is approximately 1/2 inch from the end.
- Connect the GFCI electrical outlet to the pond pump’s electrical wire. Verify that the electric cord is not in contact with water or other potentially dangerous or unsafe areas.
- Before you pour water into the pond or sink the pump in water, check that the pump is working and that there are no leaks.